Union Community VIRDI 3000 Uživatelská příručka stáhnout pdf (Strana 48)

AC-2100 User Guide 48

UNIONCOMMUNITY Co., Ltd. / 3F Hyundai Topix Bldg. 44-3 Bangi-dong Songpa-gu

Seoul, Korea (138-050)

Tel : 02-6488-3000 , Fax : 02-6488-3099, E-Mail :[email protected]

http://www.unioncomm.co.kr

value of Door_Monitor_0 port is changed. In such a case, the pre-set pop-up

message saved in the server is displayed.

The sensor monitor1 port uses the same port as the door monitor pin. Therefore,

if MenuÆ3.OptionÆ3.Set DoorlockÆ<Door Monitor> is set to ‘1’ or ‘2’, this port

is set to ‘0.None’ under any conditions.

If <Sensor Monitor1> is set to ‘1’ or ‘2’, the menu to select port state

transmission option is displayed. Port state information can be sent to the server

only once when the port state becomes “On” or whenever the port state is

changed.

1.Yes

2.No

[ESC][↑][↓][ENT]

If it is set to default setting ‘2.No’, port state

information is sent only when the port state

becomes “On”.

If it is set to ‘1.Yes’, port state information is

sent to the server whenever the port state is

changed.

Press [ENT] button to continue setting.

3.7.3.2. Sensor Monitor 2 Input Port Setting

This menu determines whether to send the state value of Door_Monitor_1 port

to the server. Setting procedures for this menu are identical to those of 3.7.3.1.

Sensor Monitor 1.

After selecting a setting value, press [ENT] button to move to the upper menu.

3.8. Device Setting

If “6.Device” is selected at the main menu, the following screen is displayed.

1.System Config

2.Card Reader

3.FP-Sensor

4.Wiegand

5.Initialize

[ESC][↑][↓][ENT]

After selecting a menu to change by pressing

[↑][↓] key, press [ENT] button.

In most cases, device settings do not require change after installation.

Therefore, it is recommended not to change them during operation

without any particular reason for doing so.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 58 59

Žádné komentáře

Union Community VIRDI 3000 Uživatelská příručka Strana 48